Your water heater is one that is used and much more costly appliances in your home, and consumes a large portion of your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving at your home heating and energy costs.
Regular flushing of the water heater is probably the single most important step you consider to prolong its service life in addition, it save energy. In a period of time, sediments enhance in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regarding the country, the average water heater lasts 3-5 years. Regularly flushing your hot water heater can double lifestyle of your water heater from 3-5 to 7-10 years. Are investigating costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater ‘s very important in today’s markets. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a nights.
To drain your water heater, initially you should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is an electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located over the water inlet line going into your water heater. You may then connect a garden hose to the drain valve located at the bottom of the heater tank. Open the drain and allow it working out until all for the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until the actual flows out gradually. This will allow air to vent from the heater and the water lines. Finally, you can turn the thermostat to be able to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your property to filter or condition the water so is actually always less corrosive to your plumbing system, particularly in areas possess hard hot water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your area to discuss options and merchandise to be fitting.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610